Hey everybody, In this article, we learn about the best tablet for eld logs. how to Samsung Galaxy Tab A 8.0 LTE eld installed in your car. To remain to install our ELD kit number 100911. The first part of the ELD kit that we’ll be installing is the pedestal and backplate onto the dash.
To do that, we are first going to determine our mounting location on this particular truck, it’s going to be right on the side of the console. Then, we need to remove the faceplate from the dash to gain access to the inside of the dash panel behind our mounting location.
The Best Tablet For Eld Logs
- Next, you’re going to want to access the other side of the dash to determine if it is safe to drill the four holes if they’re not already there. It’s important to avoid drilling near any important electronics or gauges.
- Next, you want to drill the four holes into the dash if they’re not already there. To do this, you can remove one of the pedestal bases and use it as a template for drilling your holes. Now that we have access to the backside of the dash, we’re going to want to put a screw into the pedestal base. Then we want to put that through one of the pre-drill holes and use it to line up the backplate inside the dash.
Once the pedestal base and backplate are lined up, you can go ahead and add the rest of the screws and the locknuts. Now we’re going to use a seven-millimeter wrench to hold the nuts in place while we drive the screws from the outer side.
Read more: How To Use Tablet As Second Monitor.
Follow the steps 1: best tablet for eld logs.
- Now that we have everything back together with the pedestal base and backplate installed, we can attach the rest of the pedestal by putting it on and tightening the wing nut.
- and we also want to adjust the other side for the next step by tightening the second wing up. To remove the swivel base you want to loosen the center screw using a Phillips screwdriver. And once you have it all the way loosened we can just remove the backplate by pulling it off.
- To attach the base plate to the pedestal we’re going to want to put all four screws into the base plate. After that, you want to line it up with the pedestal plate. Once we have the base plate on the pedestal we want to attach the lock nuts and use a seven-millimeter wrench and a Phillips screwdriver to tighten them down.
- Unknown Speaker
To install the quick release power dock, we’re going to want to use the same center screw and align it up with the base plate. We can then tighten the center screw until the dock is secure. - Next, we’ll want to unlock the quick-release power dock using the provided key. To do this, all you need to do is insert the key and twist.
Follow step 2: best tablet for eld logs.
then we can plug in the cigarette lighter power supply. To install your device into the tough sleeve, you first want to plug the device into the back part of the case. Then we’re going to align the top frame around the device. Make sure everything is properly lined up and then flip the whole thing over making sure it doesn’t come apart. Then we can screw all the screws that came with the tough sleeve into place
once all the screws are tightened, the device in the tough sleeve will be ready to go. Now that everything is set, we can go ahead and attach the device to the pedestal by sliding it onto the quick-release power dock. To lock the device all you need to do is press the button and you can go ahead and move and rotate the device however you need.